Jan 29, 2026 Leave a message

Room-Temperature Impact Toughness of 400 Monel

1. Room-Temperature Impact Toughness of Monel 400
Monel 400 is a single-phase nickel-copper solid-solution alloy with excellent toughness at room temperature, and its impact toughness is typically tested via the Charpy V-notch (CVN) method, which is the most widely accepted standard in engineering.
For annealed Monel 400, the standard room‑temperature Charpy V‑notch impact energy values are as follows:
Typical longitudinal Charpy V‑notch impact toughness: 126.6 J to 189.9 J (120 ft·lbf to 180 ft·lbf)
Typical transverse Charpy V‑notch impact toughness: 84.4 J to 147.7 J (80 ft·lbf to 140 ft·lbf)
These values apply to standardly annealed material with uniform microstructure, no residual stress, and no intermetallic precipitates. The alloy shows no ductile‑brittle transition at room temperature and maintains high plastic deformation capacity before fracture, making it suitable for structural components subjected to dynamic loads and shocks. Actual values can vary slightly depending on product form (sheet, bar, forging), heat treatment batch, and specimen processing quality, but they remain within the above typical range.
info-347-346info-348-351
info-348-351info-348-350
2. Hardness Increase Range of Monel 400 After Cold Working
Monel 400 has no precipitation‑hardening phase and can only be strengthened by cold working (cold rolling, cold drawing, stamping, cold forming) through plastic deformation and dislocation density increase. Hardness is commonly measured using the Rockwell B (HRB) or Brinell (HB) scales.
For fully annealed Monel 400 as the baseline:
Annealed condition hardness: approximately 65 HRB to 80 HRB, corresponding to about 120 HB to 150 HB.
After cold working, the hardness rise depends heavily on the cold reduction ratio (percentage of cross‑sectional deformation):
Mild cold working (reduction ratio ≤ 20%):
Hardness increases moderately, reaching about 85 HRB to 95 HRB, with an increment of roughly 15 to 20 HRB compared to the annealed state.
Moderate cold working (reduction ratio 20%–40%):
Dislocation density rises significantly, and hardness increases noticeably, reaching approximately 95 HRB to 105 HRB, with an increment of about 25 to 30 HRB.
High cold working (reduction ratio 40%–60%):
Severe plastic deformation leads to marked work hardening. Hardness can reach up to 105 HRB to 115 HRB, and the total hardness increment relative to the annealed baseline is around 35 to 40 HRB.
Further increasing the cold reduction beyond 60% is not recommended, as it will cause excessive internal stress, reduced ductility and toughness, and increased risk of cracking during processing or service. The hardness gain is nearly linear with the cold deformation rate within the practical processing range, and no additional heat treatment is required to retain this work‑hardened strength.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry