1. Tensile Strength and Yield Strength of Monel 400 at Room Temperature
According to common international material standards including ASTM B127 (the standard specification for Monel 400 nickel‑copper alloy plate, sheet, and strip), the typical mechanical property values at room temperature are as follows:
Tensile Strength (UTS, Ultimate Tensile Strength): The minimum standard tensile strength is 690 MPa (100 ksi).
Yield Strength (0.2% Offset Yield Strength): The minimum standard yield strength is 276 MPa (40 ksi).
These values represent the standard minimum requirements for annealed Monel 400, the most widely used heat treatment condition. Actual test results from finished products are usually slightly higher than these minimum limits.




2. Brinell and Rockwell Hardness Values of Monel 400
Under the same annealed condition that matches the above strength standards, the conventional hardness ranges are:
Brinell Hardness (HBW, typically tested with a 10‑mm ball and 3000‑kg load): The general range is 110 – 150 HBW, and the typical median value is about 120 HBW.
Rockwell Hardness:
Rockwell B Scale (HRB): The conventional range is 65 – 85 HRB, with a typical value near 70 HRB.
Rockwell C scale (HRC) is rarely used for annealed Monel 400, because its hardness is too low to obtain accurate and stable readings on the HRC scale.





