Jan 14, 2026 Leave a message

Datasheet-For-Inconel-601-1-6-(1)-(1).pdf

Information about 601 inconel

1.Density of Inconel 601
The density of Inconel 601 is typically 8.1 g/cm³ (0.292 lb/in³). This value is consistent across most product forms, including sheet, plate, bar, and wire, as density is an intrinsic material property that does not change significantly with processing.
2.Melting Range of Inconel 601
Inconel 601 has a melting range of approximately 1320–1370 °C (2408–2500 °F). This relatively narrow range is characteristic of nickel-chromium-based superalloys and reflects the material's high-temperature stability, which is essential for applications involving heat treatment, furnace components, and high-temperature service.
3.Tensile Strength and Yield Strength of Inconel 601
The mechanical properties of Inconel 601 can vary depending on factors such as heat treatment, product form, and cold work. However, typical values for the annealed condition are as follows:
Tensile strength: 650–850 MPa (94–123 ksi)
Yield strength (0.2% offset): 300–450 MPa (44–65 ksi)
These values demonstrate the alloy's good combination of strength and ductility, making it suitable for structural applications in high-temperature environments.
info-346-346info-347-349
info-347-349info-353-350
4.Elongation of Inconel 601
Inconel 601 exhibits excellent ductility, especially in the annealed condition. Typical elongation values are:
30–50% (measured in a 50 mm gauge length)
The higher end of this range is common for sheet and plate products, while bar and wire may have slightly lower elongation depending on processing. This high ductility allows for easy forming, welding, and fabrication.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry