1. Chemical Composition (Core Distinction)
2. Mechanical Properties
Critical Differences:
Room temperature: G3039 has 27% higher tensile strength and 43% higher yield strength than GH3030, due to the strengthening effect of Mo and W.
High temperature (800°C): The gap widens-G3039's tensile strength is twice that of GH3030, and its yield strength is 2.5 times higher. This means G3039 can bear far more mechanical stress at high temperatures.
Ductility: GH3030 has slightly better elongation (35% vs. 30% at room temp), making it more malleable for forming processes (e.g., bending, welding).
3. High-Temperature Performance
3.1 Oxidation Resistance
At 800–900°C: Both perform similarly, with no significant oxidation after long-term exposure.
Above 900°C: GH3030's oxidation resistance is slightly better. The Mo/W in G3039 may form volatile oxides at ultra-high temperatures, weakening the protective film (though this effect is minimal below 950°C).
3.2 Creep Resistance
GH3030: Suitable for low-stress high-temperature environments. Its 1000-hour creep rupture strength at 800°C is only ~100 MPa, so it cannot withstand high stress for extended periods.
G3039: Designed for high-stress high-temperature scenarios. Its 1000-hour creep rupture strength at 800°C reaches ~300 MPa-three times that of GH3030. This is because Mo and W form stable intermetallic phases (e.g., Ni₃Mo) that inhibit grain boundary sliding (the main cause of creep).


4. Typical Application Scenarios
GH3030 Applications
Heat exchanger tubes and furnace parts in petrochemical plants (working temp: 600–800°C, low stress).
Welding materials for high-temperature components (due to good weldability and ductility).
Internal structural parts of jet engines (e.g., combustion chamber liners) that operate at high temperatures but bear low mechanical stress.
G3039 Applications
High-pressure turbine blades and vanes in gas turbines (working temp: 700–900°C, high centrifugal stress).
Core components of nuclear power plant heat exchangers (withstands high temperature, high pressure, and radiation).
High-temperature fasteners and structural parts in aerospace engines (requires long-term stability under high stress).
5. Processability
GH3030: Better processability. Its simple composition and high ductility make it easy to hot-work (e.g., forging, rolling) and cold-work (e.g., stamping). Weldability is also excellent, with no easy cracking.
G3039: Slightly poorer processability. The addition of Mo and W increases alloy hardness and brittleness, requiring higher temperatures for hot-working. Welding needs preheating and post-weld heat treatment to avoid cracking.







