Grade 2 is commercially pure titanium, and its creep resistance is relatively low compared with titanium alloys, but it still exhibits predictable and usable behavior at moderate elevated temperatures.
Creep refers to the slow plastic deformation of a material under constant stress at a fixed temperature over time. For Grade 2 titanium, creep becomes a design consideration when the service temperature exceeds approximately 150°C (300°F), and its influence becomes increasingly significant as temperature and load increase.
At temperatures below 315°C (600°F), Grade 2 maintains moderate creep resistance. It is widely used in low‑stress and non‑structural high‑temperature applications such as heat exchangers, piping systems, and components in processing equipment. However, under high stress and high temperature conditions, pure titanium deforms more easily than alloyed grades like Ti‑6Al‑4V or other heat‑resistant titanium alloys.
The creep behavior of Grade 2 is strongly affected by:
Temperature: Higher temperatures drastically reduce creep strength and accelerate deformation.
Stress level: Higher applied stress shortens creep life and increases creep strain rate.
Microstructure: Grain size plays a role; finer grain sizes generally reduce creep resistance, while coarser microstructures can improve it.
Exposure time: Prolonged high‑temperature exposure promotes creep deformation and stress relaxation.
Since Grade 2 contains no strengthening alloying elements such as aluminum, vanadium, or tin, it lacks the high‑temperature stability and creep resistance provided by precipitation hardening or solid‑solution strengthening in titanium alloys. Therefore, Grade 2 is not recommended for heavy‑duty structural components subjected to high loads at temperatures above 300–350°C for long periods.




In summary:
Below 150°C: Excellent dimensional stability; creep is negligible.
150–315°C: Moderate creep behavior; acceptable for low‑to‑medium stress applications.
Above 315°C: Creep resistance drops significantly; not suitable for high‑stress structural use.
For high‑temperature and high‑creep‑resistance requirements, titanium alloys or other heat‑resistant materials are typically recommended instead of Grade 2 commercially pure titanium.





