What Are the Differences Between Cold Working and Hot Working Properties of Pure Copper?
Pure copper exhibits distinct differences in formability, microstructure, mechanical properties, and application suitability between cold working and hot working. These differences arise from the temperature range, deformation mechanism, and microstructural evolution involved in each process. Below is a detailed comparison.
Hot working refers to plastic deformation carried out at temperatures above the recrystallization temperature of pure copper, typically above 300°C–400°C. At such temperatures, copper has extremely high ductility and low deformation resistance.
Dislocations generated during deformation can be rapidly eliminated through dynamic recovery and recrystallization, preventing significant work hardening. Therefore, large plastic deformation can be achieved in a single pass, making it suitable for rough forming and large-scale deformation processes. Common hot working methods for pure copper include hot rolling, hot extrusion, and hot forging. During hot working, grain growth may occur if the temperature is too high or holding time is too long, leading to slightly coarser grains and lower strength compared to cold-worked copper. However, hot working effectively breaks up cast structures, reduces porosity, and improves internal soundness and homogeneity. It is mainly used in the initial stages of production to transform cast ingots into semi-finished products such as plates, rods, tubes, and bars.




Cold working is performed at room temperature or below the recrystallization temperature of pure copper. Although pure copper has good room-temperature ductility, deformation at low temperatures causes intense dislocation multiplication and accumulation, resulting in significant work hardening. With increasing deformation, strength and hardness rise sharply, while ductility and toughness decrease.
This characteristic allows cold working to precisely control dimensions and surface quality. Products have smooth surfaces, high dimensional accuracy, and controllable strength. Typical cold working processes include cold rolling, cold drawing, stamping, and bending. Due to work hardening, excessive deformation can cause cracking, so intermediate annealing is often required to restore ductility. Cold-worked pure copper has a stretched, fibrous microstructure and preferred orientation, which enhance its strength and hardness for applications requiring high dimensional precision and mechanical strength.
In terms of physical and mechanical properties, hot-worked pure copper features low hardness, moderate strength, high ductility, and excellent electrical conductivity. It is suitable for parts requiring good formability and conductivity. Cold-worked pure copper has significantly higher hardness and tensile strength, with reduced elongation but excellent dimensional stability. Its electrical conductivity is slightly lower than that of hot-worked or annealed copper due to lattice distortion caused by dislocations, but still meets most electrical application requirements.
Surface quality and dimensional accuracy also differ greatly. Hot working may leave oxide scale and relatively rough surfaces, requiring subsequent pickling or machining. Cold working provides excellent surface finish and tight dimensional tolerance, suitable for final-stage precision forming.
In summary, hot working of pure copper is characterized by low deformation resistance, high deformability, dynamic recrystallization, and improved internal structure, mainly used for primary forming. Cold working is characterized by work hardening, high precision, good surface quality, and adjustable strength, used for precision forming and performance strengthening. Reasonable matching of hot working, cold working, and annealing processes enables efficient production of high-performance pure copper products for industries such as electronics, electric power, machinery, and heat exchange.





