Jan 13, 2026 Leave a message

astm-b444-(1)-(1).pdf

Can Inconel 625 resist corrosion by strong acids

Can Inconel 625 resist corrosion by strong acids such as hydrochloric acid (HCl) and sulfuric acid (H₂SO₄)?

Inconel 625 is not generally considered resistant to strong HCl or strong H₂SO₄ under most process conditions, especially at higher concentrations and temperatures. Its excellent corrosion resistance comes primarily from high chromium (Cr) and molybdenum (Mo) contents, which provide strong passivation and resistance to pitting/crevice corrosion in chloride-containing environments, but not immunity to reducing acids like HCl and H₂SO₄.

1.Hydrochloric acid (HCl)

HCl is a strongly reducing acid, and Inconel 625 will corrode significantly in all but very dilute, low-temperature HCl.

Even at room temperature, concentrations > ~5–10% HCl typically cause rapid general corrosion and potential pitting.

As temperature increases, corrosion rates rise sharply.

Aerated (oxygen-containing) HCl may show slightly better resistance than deaerated HCl, but this is often insufficient for practical service.

Inconel 625 is not recommended for continuous exposure to HCl unless the conditions are very mild (e.g., trace amounts, low temperature, well-aerated, and with strict control of contaminants).

2.Sulfuric acid (H₂SO₄)

H₂SO₄ behavior is strongly dependent on concentration and temperature.

Inconel 625 can show acceptable resistance in certain narrow ranges (e.g., very dilute acid or highly concentrated "oleum"/near-anhydrous conditions) where the environment is less aggressively reducing and passivation is possible.

However, in the mid-concentration range (roughly 10–70% H₂SO₄)-which is common in many industrial processes-H₂SO₄ is strongly reducing, and Inconel 625 will suffer high general corrosion rates.

Higher temperatures further accelerate attack.

Therefore, Inconel 625 is not a standard material of choice for most H₂SO₄ service; alloys with higher Mo and Cu (e.g., Hastelloy C-series, Alloy 20, or certain stainless steels in specific ranges) are often preferred, depending on concentration and temperature.

info-346-348info-352-353

info-352-353info-347-352

Key takeaway

Strong HCl: Inconel 625 is not resistant (except very dilute, low-temperature, well-controlled cases).

Strong H₂SO₄: Inconel 625 is generally not resistant in the commonly encountered mid-concentration range; resistance is only possible in very dilute or very concentrated conditions.

For strong acids, always refer to corrosion rate data (mm/year or mpy) for the specific concentration, temperature, aeration, and impurity levels (e.g., chlorides, oxidizing species).

Send Inquiry

whatsapp

Phone

E-mail

Inquiry